jsz123
Contributor
Any hand specialist coders that can assist me with this ortho case please? (just a bit overwhelmed with this one)
PROCEDURE:
1. Release of left ring finger Dupuytren's contracture.
2. Release IP joint, left ring finger.
3. Release intrinsic tightness/central slip, left ring finger.
Approximately 4 cm Brunner type incision was made from the DIP crease into the mid palm. Dissection was taken down and we spent approximately 25 minutes meticulously dissecting out both the radial and ulnar digital nerves from the palm out to the distal aspect of the finger. The underlying flexor tendons were identified, and protected. We very carefully dissected out the A2 and the A4 pulleys, which were protected. The Dupuytren's cord was excised from the palm including several contractures, the cord, and a small nodule, all the way from the palm to the level of the distal aspect of the middle phalanx. Once we had completely excised all the Dupuytren's, attention was then turned to the PIP joint release.
The A5 pulley was opened, and dissection was taken down through the A5 pulley to the PIP joint. The PIP joint was exposed by excising a portion of the volar plate. With the volar plate exposed. I was still unable to extend the finger. For this reason, collateral ligaments, both on the radial and ulnar side were released from the distal aspect of the middle phalanx. At this point, I was able to get the finger into full extension, without difficulty. She still did have a significant boutonniere's deformity, and for this reason, approximately 0.5 cm incision was made over the dorsal aspect just proximal to the PIP joint. This did significantly improve our flexion. We had full extension of both the PIP joint, and full flexion of the DIP joint, but she still lacked some active extension. I think this is likely secondary to lengthening of the extensor tendons, and she was able to extend the finger quite well with the wrist in a flexed position. I elected at this point, however, to pin the PIP joint in extension. This was performed from the ulnar side with a single 0.045 K-wire under direct visualization. At this point, the PIP joint was straight. Wounds were then copiously irrigated, closed loosely with 4-0 nylon suture. There was no need for Z-plasty, or soft tissue rearrangement.
PROCEDURE:
1. Release of left ring finger Dupuytren's contracture.
2. Release IP joint, left ring finger.
3. Release intrinsic tightness/central slip, left ring finger.
Approximately 4 cm Brunner type incision was made from the DIP crease into the mid palm. Dissection was taken down and we spent approximately 25 minutes meticulously dissecting out both the radial and ulnar digital nerves from the palm out to the distal aspect of the finger. The underlying flexor tendons were identified, and protected. We very carefully dissected out the A2 and the A4 pulleys, which were protected. The Dupuytren's cord was excised from the palm including several contractures, the cord, and a small nodule, all the way from the palm to the level of the distal aspect of the middle phalanx. Once we had completely excised all the Dupuytren's, attention was then turned to the PIP joint release.
The A5 pulley was opened, and dissection was taken down through the A5 pulley to the PIP joint. The PIP joint was exposed by excising a portion of the volar plate. With the volar plate exposed. I was still unable to extend the finger. For this reason, collateral ligaments, both on the radial and ulnar side were released from the distal aspect of the middle phalanx. At this point, I was able to get the finger into full extension, without difficulty. She still did have a significant boutonniere's deformity, and for this reason, approximately 0.5 cm incision was made over the dorsal aspect just proximal to the PIP joint. This did significantly improve our flexion. We had full extension of both the PIP joint, and full flexion of the DIP joint, but she still lacked some active extension. I think this is likely secondary to lengthening of the extensor tendons, and she was able to extend the finger quite well with the wrist in a flexed position. I elected at this point, however, to pin the PIP joint in extension. This was performed from the ulnar side with a single 0.045 K-wire under direct visualization. At this point, the PIP joint was straight. Wounds were then copiously irrigated, closed loosely with 4-0 nylon suture. There was no need for Z-plasty, or soft tissue rearrangement.